UG nx2.0打印设置|UG,Unigraphics,打印,设置

一、设置打印机
开始/程序/ugnx2/unigraphics tools/pqmgr;
      Connecting to Plot Queuing System at Node: lcy ...  Connected.
Plot Queue Manager 1.0.0.21
Enter Command or "help"
PQM_lcy-*>qmod ljet3
Accept Defaults With A Carriage Return
Enter Queue Name (16 Char. Max.)
Default = LJET3
Enter Despooler Name (8 Char. Max.)
Default = UGIIHP
Enter Plotter Vendor (16 Char. Max.)
Default = HEWLETT-PACKARD
Enter Plotter Type (E=Electrostatic; P=Pen)
Default = E
Enter Plotter Model (16 Char. Max.)
Default = 7600
Enter Plotter Switches (132 Char. Max.)
Default = /2/LJ/SP=MW/AR
Enter Media Control (C=Continuous; N=Non-Continuous)
Default = C
Enter Distance Between Plots
Default = 0
1 = Direct
2 = System Queue
3 = Disk File
4 = Both Direct And File
5 = Both Queue And File
Enter Output Mode
Default = 2
3                                             &&此处选３，保存到磁盘
Enter Directory Pathname (132 Char. Max.)
Default =
e:\plot                                       &&此处指定保存路径和文件夹
Enter Message Com Line (16 Char. Max.)
Default =
Enter Steps Per Inch
Default = 1016
LJET3
   Despooler Name          = UGIIHP
   Plotter Vendor          = HEWLETT-PACKARD
   Plotter Type            = Electrostatic
   Number Of Pens          = 16
   Controller ID           =
   Plotter Model           = 7600
   Plotter Switches        = /2/LJ/SP=MW/AR
   Media Control           = Continuous Form
   Distance Between Plots  = 0
   Output Mode             = Disk File
   Plotter Com Line        =
   System Queue Name       = \\MYNODE\LJET3_QUEUE
   Directory Pathname      = E:\PLOT
   Tape Density            = 1600
   Message Interval        =
   Message Com Line        =
   Horizontal Maximum      = 0
   Vertical Maximum        = 0
   Steps Per Inch          = 1016
   Optimization Level      = None

PQM_lcy-*>Start ljet3       启动打印机
PQM_lcy-*>Bye  　　　　　　退出打印设置

二、生成hpp打印文件
1、 打开图纸
2、 File - plot…
3、 Plot Quenes on Node 选  Ljet3
4、 Build plot file
三、打印文件
用ViewCompanion软件打开E:\PLOT\的hpp文件，即可打印